Redis: Difference between revisions
Jump to navigation
Jump to search
Line 40: | Line 40: | ||
sudo systemctl restart redis-server | sudo systemctl restart redis-server | ||
sudo systemctl status redis-server | sudo systemctl status redis-server | ||
== Pubsub == | |||
{| | |||
|valign='top'| | |||
<source lang="bash"> | |||
redis-cli | |||
SUBSCRIBE pubsub:queue | |||
:' | |||
Reading messages... (press Ctrl-C to quit) | |||
1) "subscribe" | |||
2) "pubsub:queue" | |||
3) (integer) 1 | |||
1) "message" | |||
2) "pubsub:queue" | |||
3) "Hello" | |||
' | |||
</source> | |||
|valign='top'| | |||
<source lang="bash"> | |||
redis-cli | |||
PUBLISH pubsub:queue Hello | |||
</source> | |||
|} | |||
== References == | == References == |
Revision as of 18:27, 30 May 2022
sudo apt install redis-server
sudo vim /etc/redis/redis.conf
Redis Config
# If you run Redis from upstart or systemd, Redis can interact with your
# supervision tree. Options:
# supervised no - no supervision interaction
# supervised upstart - signal upstart by putting Redis into SIGSTOP mode
# supervised systemd - signal systemd by writing READY=1 to $NOTIFY_SOCKET
# supervised auto - detect upstart or systemd method based on
# UPSTART_JOB or NOTIFY_SOCKET environment variables
# Note: these supervision methods only signal "process is ready."
# They do not enable continuous liveness pings back to your supervisor.
supervised systemd
sudo mkdir /var/run/redis
sudo chown -R redis:redis /var/run/redis
sudo systemctl restart redis-server
sudo systemctl status redis-server
###################<OR>###################
sudo vim /etc/systemd/system/redis.service
[Service]
Type=forking
ExecStart=/usr/bin/redis-server /etc/redis/redis.conf
ExecStop=/bin/kill -s TERM $MAINPID
ExecStartPost=/bin/sh -c "echo $MAINPID > /var/run/redis/redis.pid"
PIDFile=/run/redis/redis-server.pid
sudo systemctl daemon-reload sudo systemctl restart redis-server sudo systemctl status redis-server
Pubsub
redis-cli
SUBSCRIBE pubsub:queue
:'
Reading messages... (press Ctrl-C to quit)
1) "subscribe"
2) "pubsub:queue"
3) (integer) 1
1) "message"
2) "pubsub:queue"
3) "Hello"
'
|
redis-cli
PUBLISH pubsub:queue Hello
|
References
| ||